About 'DP_MODE' pin in P3509_A01 schematic

Robotics & Edge Computing Jetson & Embedded Systems Jetson Xavier NX
1

What’s the purpose of the ‘DP_MODE’ and the derived ‘DP_MODE_LS’ in Xavier NX DevKit’s schematic version A01? As in the DG, there is no such FETs between NX module and the DP connector.

Thanks.

3

That is for DP++ support (passive DP to HDMI dongle). We added that support into the board level and leave it there in case it is enabled in the future.

1 Like
5

In the future? That means it’s no supported for now? So we can’t use a simple DP to HDMI dongle to connect to a HDMI display from DP0?

6

It’s not supported now.

1 Like
7

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.