After i2cset, nano can not boot and the serial port has no print information. When reflashing the nano with command “sudo ./flash.sh jetson-nano-emmc mmcblk0p1”, the terminal prints “Parsing board information failed.”
We use emmc nano board, without SD card.
There is no update from you for a period, assuming this is not an issue any more.
Hence we are closing this topic. If need further support, please open a new one.
Thanks
hello clevor18,
may I know what’s the modification you’d done by i2cset?
thanks
Sry, reply to you after such a long time. We modified the data in eeprom on Nano by i2c tools (i2cset). Based on what I learn from internet ro nivida forum, “Parsing board information failed.” maybe caused by the data verification failed on eeprom.
1 Like