AGX ORIN 10G Ethernet 4 channels

[kcs]

Hello, nvidia teams.
We use a Jetson AGX ORIN(64GB) with custom board L4T 35.5.0.

We use currently 10G Ethernet 1 channel with AQR113C chip. (we have configured the same circuit as AGX ORIN EVKIT.)

We would like to use 4 channels of 10G Ethernet by hardware modification of UPHY signals connected to PCIe x16 Connector.(UPHY_TX7~9, UPHY_RX7~9)

1. Is it possible to configure 4 channels of 10G Ethernet?
2. If we configure 4 channels, is there anything we need to modify in SW?

Thanks.

[kayccc]

Sorry for the late response.
Is this still an issue to support?

[kcs]

Yes, it has not been resolved yet. still problem

[Trumany]

Hi, only UPHY6 can be used for MGBE.