agx orin 如何在bootloader阶段设置Gpio 状态 及做一个复位过程 按照手册修改pimmux没有任何作用 在bsp36.2中
Hi,
Please check the quick start in developer guide and make sure you follow the steps one by one:
https://docs.nvidia.com/jetson/archives/r36.3/DeveloperGuide/IN/QuickStart.html
If the device still cannot be flashed/booted, please refer to the page to get uart log from the device:
https://elinux.org/Jetson/General_debug
If you are using custom board, you can compare uart log of developer kit and custom board to get more information.
Thanks!
Hi wang_qing_jiu,
Are you using the devkit or custom board for AGX Orin?
Could you elaborate for your requirement?
Do you want to configure the GPIO in UEFI(bootloader)?
Or configuring the default state for specific GPIO?
Which PIN you want to control and what’s the desired state?
L4T R36.2 is a developer preview release.
Please move to the latest Jetpack 6.1(R36.4.0) to verify.
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.