assembly_desgin pdf missing measurements...

I was going through the process of designing an enclosure for my dev boards… and I ran upon a missing measurement in the “assembly drawing” pdf. Can anyone tell me the measurement from the “PCBA ORIGIN” to the top screw hole? The drawing only shows from the origin to the top edge of the board.

Additionally, can someone give me a rough estimate as to the height of the board with the module & heatsink+fan included? This would really save me having to dig out my calipers & best-guess it.

The measurement is 154.92 mm.

You can get the board thickness in stackup file which is 1.575 mm.

The total height is about 33 mm.

Also you can refer to this topic for more info of measurement: