Autochaffuer[P2379] Hanging when It starts

Dear,

It is box-opened new one. At the first booting, P2379 ubuntu did not start well, instead stuck at the boot-log step.
When trying to install 5.0.10.3, newly released version, exactly same thing happened.

I attach version information of Aurix as follow

SW Version: DRIVE-V5.0.5-P2379-EB-Aurix-With3LSS-4.02.02
Compilation date: Nov  8 2017, 16:03:03

No Problem it is.

lsusb command returns as follow;

ubuntu@ubuntu-desktop:~$ lsusb
Bus 001 Device 002: ID 8087:8001 Intel Corp.
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 003 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 002 Device 031: ID 0403:6011 Future Technology Devices International, Ltd FT4232H Quad HS USB-UART/FIFO IC
Bus 002 Device 030: ID 0403:6011 Future Technology Devices International, Ltd FT4232H Quad HS USB-UART/FIFO IC
Bus 002 Device 029: ID 0424:2514 Standard Microsystems Corp. USB 2.0 Hub
Bus 002 Device 028: ID 04d9:a0be Holtek Semiconductor, Inc.
Bus 002 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub

Any help about it?

Thanks

Additional Info:

Tegra B side returns the same result and stuck.

Thanks,

Updates!

I disassembled everything and reassembled all IO cables.

And it works!

Thanks


After this update(5.0.5.0bL_b3),
I installed DriveInstaller again, 5.0.10.3, and stuck at the same step.

Even several times of reboot and re-installation,
no further positive results.

I should ask your advice again.

Thanks

Dear ddpx2,

That’s weird, can I know if you updated Aurix FW?
And could you please check “Place the AURIX switch into programming (RUN) mode.”? Thanks.

Dear Steve,

I checked AURIX FW, 4.02.02 via Aurix console, and RUN mode as well.

Thanks,

Dear ddpx2,

Could you try to update Aurix FW tto 4.02.04?
Aurix FW : SW Version: DRIVE-V5.0.10-P2379-EB-Aurix-With3LSS-4.02.04

Dear Steve,

I wonder if I make you confused between two versions.
DriveInstaller 5.0.5.0 and 5.0.10.3.
AURIX FW versions are 4.02.02 and 4.02.04 each other.

For AURIX 4.02.04, I have to install 5.0.10.3 again.

After test, I’ll update it.

Thanks

Dear Steve,

I cleared this issue as following, and thank you very much;

  1. Install DriveInstaller 5.0.10.3
  2. AURIX FW update to 4.02.04 by manual
  3. New issue occurs here, ‘A start job is running for setup…’
    Connect DPX2 to DHCP networks instead of static IP.

Thanks,