This post has been posted another Nvidia discussion group I’m trying to get as much feed back as possible
I want to thank all the individuals and the great replies from previous posting
Not sure how to word this question.
I use Autodesk Inventor 2010
My graphic cards are FX-1800 and FX-3800 as a loaner card for testing
I do a lot of simulations, there a major performance improvement with FX-3800 over the FX-1800; I want to get a major performance increase by using a Tesla C-1060
Assumption: I donâ€™t think there an interface which could off load certain Autodesk processes to the C-1060 and to a Nvidia graphic card, I could wrong here.
- If I use a C-1060 Tesla Card in conjunction with either an FX-1800, FX-3800 or and any Nvidia Cuda supported products, would I have much of performance gain. On the surface I want to say yes.
- If I developed a general decision matrix for what task I would off load to the C-1060 what might they be?
- To my knowledge there no automatic detection by an Nvidia Cuda product of a C-1060 in system and there manager to decide what to off load to the C-1060.
- Any else you want to input