I have a SX6512 with two management modules and upon booting it appears to boot fine (which I watched through the consoles). The problem is whenever I ssh to it or http to it I get the following messages…
Management Module 1
System is initializing! This may take a few minutes.
Modules are being configured, 27 modules remain to be configured
Management Module 2
System is initializing! This may take a few minutes.
Modules are being configured, 74 modules remain to be configured
AND I never get to a switch prompt. It’s been sitting with the above messages for over an hour and I’m afraid to remove power and reboot.
Any suggestions/ideas?
Thanks,