Can two Orin SOM connected through UPHY

Yes :

In our design , two orins need data transfer,through UPHY8 as MGBE and MAC to MAC connection.

So you want to use config #3?

Yes:
I know config #3 is not yet fully supported,but I think it is most suitable for us.

Hi,

Actually, config #3 won’t be supported. There would be announcement soon.

why won’t be supported ? any difficult problem?

Will it not support CONFIG#3 in the future?

Yes, it will not be supported.

Does this mean that the Orin will never support 4 10GbE? That is a pretty major capability to decide not to support after promising at launch.

Hi NV Team
Can you please clarify detail for UPHY config#3.
What is means “Actually, config #3 won’t be supported. There would be announcement soon.” ???
From the Jetson_AGX_Orin_Design_Guide_DG-10653-001_v1.0


Thanks
Yutai

We will release a adaptation guide document soon and it will show config#3 not supported.

Should be in this link.

Hi Wayne
I double check the documents. “Adaptation_and_Bringup_for_Jetson_AGX_Orin” UPHY setting.
Below is my understand, Please help confrim.
The config 1 dont support MGBE. Change to PCIex8
The config 2 PCIex8 change to PCIex4 and MGBEx4.
The config 3 dont support in future.

Thanks
Yutai

@WayneWWW
Any update about the phy mapping ?
Below is my understand, Please help confrim.
The config 1 dont support MGBE. Change to PCIex8
The config 2 PCIex8 change to PCIex4 and MGBEx4.
The config 3 dont support in future

Thanks
Yutai

No, your understanding is wrong… please check the design guide document.

@WayneWWW
Sorry, Some confuse your comments. config#3 not supported.
But from the “Adaptation_and_Bringup_for_Jetson_AGX_Orin” The Lane4,5,6,7 support MGBE0,MGBE1,MGBE2,MGBE3
So can you please give me detail clear description for each UPHY Lane support feature in both config 1 and 2.


Thanks
Yutai

Please just follow the design guide. Only pure config #1 and #2 are supported. Same as what the design guide shows.

Q1. Why “Adaptation_and_Bringup_for_Jetson_AGX_Orin” dont match design guide ?
Q2. You means we must follow up “Jetson_AGX_Orin_Design_Guide_DG-10653-001_v1.0” Table 6-4
Only config #1 and #2 support, #3 dont support.** It is final decision from NVIDIA?**
If YES, please update design guide.

Any update?
Thanks

Yes, we will update the design guide soon.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.