Carrier board config EEPROM

Dear All,

I’m looking for the explanation about EEPROM at the page 24 of the Carrier board schematics.

There is no any comments i a hardware documentation. What for? Which data should be there? And so on…

I would appreciate your explanations.

Thank you and best regards,
Alex

I’ve found an answer for the camera board, but not for the carrier board…

https://devtalk.nvidia.com/default/topic/904943/eeprom-on-tx1-camera-board/

According schematics the BOARDID EEPROM is set on GEN3_I2C at addr 7’57h

I cannot find any
reg = <0x57>

in DT

You can refer to this topic: [url]https://devtalk.nvidia.com/default/topic/932024/jetson-tx1/using-x1-module-on-different-embedded-board/3[/url]

Thanks.

As far I understand I can skip it in my design, right?

Best regards,
Alex

Yes

Thanks a lot!
Your answer is very helpful for me!