Code changes in robot.py and motor.py to switch to combination of l298n/pca9685 in place of adafruit motor driver as given in nvidia

Robotics & Edge Computing Jetson & Embedded Systems Jetson TX2
,
3

Hi,

Thanks for reaching out!

You might find the following datasheet helpful.

There is a code sample provided for Arduino. On Jetson, you will most likely need to use the jetson-gpio library.

A first step would be to use the jetson-gpio library to control the IO pins on the motor driver for enable / PWM.

Once you’re able to turn the motors, I may be able to provide guidance on how to emulate the JetBot Robot class, if you’re looking to directly use the JetBot Jupyter notebooks.

Hope this helps please let me know if you have any questions!

Best,
John