I’m moving from a raspberry pi 4 to a TX2. When modifying pins on the pi4 all I had to do was add the following to the usercfg.txt:
dtoverlay=w1-gpio #enables 1 wire
enable_uart=0 #disables uart pin 8 10
dtoverlay=uart2 #enable uart2 pin 27 28
dtparam=i2c_arm=off #disable 12c pin 27 28
dtparam=i2s=off #disable 12c pin 27 28
Is there a way to make the above changes to the TX2 pins? (preferably without re-flashing)