CSI/MiPi CLK_P/N swap

Autonomous Machines Jetson & Embedded Systems Jetson Xavier NX
1

I am looking at the A203-V2 Carrier Board and I notices that when comparing the CSI connector to the NX Dev board, I notice that all the pins match EXCEPT for the MIPI_CLK_P/N pins. They are flipped.

So the question is, does connecting a P to an N pin cause issue? Part of me thinks it would because they are obviously different, however given they are diff-pairs I could see a way that it may work with them connected via P to N and N to P.

3

Hi, for NX, the P/N should not be flipped. You can check with vendor for the reason.

1 Like
5

Turns out the documentation was incorrect and the pins matched the dev board in reality.

6

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.