Customizing the PCIe for custom carrier board

Autonomous Machines Jetson & Embedded Systems Jetson AGX Orin
,
1

Hi
I’m configuring the UPHY lanes for a custom carrier board. This carrier board has a PCIe x2 device connected and the USB ports remain unchanged.

According to “Jetson AGX Orin Series Product Design Guide” the Orin has the following configuration:

Snipaste_2022-04-12_18-53-34
Snipaste_2022-04-12_18-53-34604×612 74.3 KB

My M.2 Key M occupies the UPHY_TX/RX 2-5

How can I assign those pins to the M.2 Key’s device?

I read at “Jetson AGX Xavier Platform Adaptation and Bring-Up Guide - UPHY Lane Assignment” that that is possible for the AGX Xavier platform. But I wanted to know how to do that customization (assigning those pins M2. Key M) for the Orin.

If it is, is there any example as the one for the Xavier that I can follow?

Maybe something like this (this is a USB use case) but for PCIe:

image

2

Hi,

Just an update. This content is wrong. We do not support the configuration #3. Only config #1 and #2 are supported.

Also, only those configurations are available. Not able to change.

Your design seems not able to work on Jetson Orin in both software and hardware aspect.

1 Like
3

So there is no way to remap the Orin functions (PCIe, USB, etc) to other Pins?

4

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.