D-phy 4lane porting for designing interposer board (Jetson Orin)

[dhseong]

Hi, All.

Now i am trying to design my custom board to bring-up our camera by using Jetson orin. Our camera was originally driven by D-phy 4-lane (CLK,D0,D1,D2, and D3) at another platform and i wanted to bring-up our camera at Jetson Orin also using 4-lane D-phy.

I am trying to find the specific guideline at Jetson Hardware Design Guide but i couldn’t find the guideline yet.

To summraize, where i have to connect the MIPI D-phy nets to Camera connector (for only one camera) ?

Now i designed my custom board as below.

[For J509 connector (Jetson Orin)]

CLKP, CLKN => #7, #8 pin
D0P, D0N => #1, #3
D1P, D1N => #13, #15
D2P, D2N => #2, #4
D3P, D3N => #8, #10.

Thank you.

Best Regards,
Donghyun Seong.

[Trumany]

Please post to AGX Orin zone next time.

You can use CSI0 + CSI1 data pins with CSI0 CLK pins.