Device tree DSI display init commands

Robotics & Edge Computing Jetson & Embedded Systems Jetson TX1
2

Hello,
Can you refer to DTS source, like arch/arm/boot/dts/panel-s-wqxga-10-1.dtsi?
the command should like the following:

nvidia,dsi-init-cmd =
/* Long  Packet: <PACKETTYPE[u8] COMMANDID[u8] PAYLOADCOUNT[u16] ECC[u8] PAYLOAD[..] CHECKSUM[u16]> */
/* Short Packet: <PACKETTYPE[u8] COMMANDID[u8] DATA0[u8] DATA1[u8] ECC[u8]> */
/* For DSI packets each DT cell is interpreted as u8 not u32 */

<TEGRA_DSI_PACKET_CMD DSI_GENERIC_LONG_WRITE 0x3 0x0 0x0 0x10 0x00 0x2A 0x0 0x0>,
<TEGRA_DSI_DELAY_MS 20>,
<TEGRA_DSI_PACKET_CMD DSI_DCS_WRITE_0_PARAM DSI_DCS_NO_OP 0x0 0x0>,
<TEGRA_DSI_DELAY_MS 20>,
<TEGRA_DSI_PACKET_CMD DSI_GENERIC_LONG_WRITE 0x3 0x0 0x0 0x10 0x01 0x01 0x0 0x0>,
<TEGRA_DSI_DELAY_MS 20>,
<TEGRA_DSI_PACKET_CMD DSI_DCS_WRITE_0_PARAM DSI_DCS_NO_OP 0x0 0x0>,

Those definitions of constants can be found in kernel source.

br
ChenJian