ACT/LINK is connected to GND thru a switch, there is no voltage level request for the pins. The power supply is 3.3V to LED as you can see in P3509 schematic.
Related topics
| Topic | Replies | Views | Activity | |
|---|---|---|---|---|
| Jetson NX power LED is always off! | 13 | 699 | December 7, 2022 | |
| Xavier NX RJ45 LED behavior control via GBE_LED_LINK_ACT/GBE_LINK_100/GBE_LINK_1000 | 13 | 902 | October 18, 2021 | |
| Xavier NX : using GPIO tx, rx making LED indicator | 6 | 1022 | October 18, 2021 | |
| How to control ETH1 leds on jetson xavier nx | 2 | 1173 | August 30, 2021 | |
| Only 3v from 5v pins (J12 pin 2, pin 4) | 5 | 745 | October 18, 2021 | |
| How to change the lighting condition of the RJ45:LINK_LED | 5 | 746 | October 18, 2021 | |
| PEX_Lx_RST_N/PEX_Lx_CLKREQ_N signals electrical level | 2 | 517 | October 18, 2021 | |
| Jetson Xavier System Pins | 4 | 1049 | October 18, 2021 | |
| TX2 GBE LED operation | 48 | 4855 | October 18, 2021 | |
| Jetson Nano and AGX Xavier GPIO Level 3.3V or 1.8V | 4 | 2190 | October 18, 2021 |