Flashing AGX Industrial with Rogue Carrier failure

Autonomous Machines Jetson & Embedded Systems Jetson AGX Xavier
1

Hi

I’m having difficulties flashing the Xavier AGX Industrial using Connect Tech’s Rogue Carrier (AGX101).
I’m following the guide supplied by Connect Tech (https://connecttech.com/resource-center/kdb373/)

  • I’m using a 64-bit Ubuntu 18.04 PC as the host PC.
  • Jetpack 4.6

I get stuck at:
[ 19.2226 ] Sending bootloader and pre-requisite binaries
[ 19.2256 ] tegrarcm_v2 --download blob blob.bin
[ 19.2272 ] Applet version 01.00.0000
[ 19.2479 ] Sending blob
[ 19.2483 ] […] 100%
[ 20.1756 ]
[ 20.1805 ] tegrarcm_v2 --boot recovery
[ 20.1822 ] Applet version 01.00.0000
[ 20.2042 ]
[ 21.2101 ] tegrarcm_v2 --isapplet
¨
After this, nothing happends. What am I doing wrong?

Thank you in advance.

3

Please contact with vendor and check if their board supports the AGXI.

4

It is possible that the manufacturers BSP has not yet been updated for the AGXI.
Some further updates:
*I get “CPU bootloader not running on device” when continuing flashing
*The “lsusb” commands lists Nvidia corp “0955:7919”

Their BSP uses Jetpack 4.6 (https://connecttech.com/ftp/Drivers/CTI-L4T-AGX-32.6.1-V001.tgz)

5

Hi there,
Our support team is hard at work to integrate our products with the AGX Xavier Industrial. Keep an eye on this page, where we’ll include Release Notes for each JetPack update.

Thanks,
Kara

6

Hello, thanks for the update. I’ve successfully flashed the AGX Industrial on the Rogue(AGX101), but im only successfull when using “jetson-agx-xavier-industrial.conf”,but not using CTI’s BSP. Hopefully we’ll get an update soon.

8

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.