Hi, I tried to a custom made carrier board to flash the TX2, and it will stack at 64% when I’m trying to flash the TX2’s image which cloned from other places, and return code value 3, any ideas about what the return value’s meaning? and how to fix it? thanks.

Flashing image to TX2 failed

william_wu July 14, 2017, 1:00pm 2

I found that it is because the host USB is USB3.1. When I change the host USB port to an USB 3.0 port this situation will not happen again

Topic		Replies	Views
flash failed Tx2 Jetson TX2	14	2272	October 18, 2021
Problem flashing TX-2 Jetson TX2	39	17584	October 18, 2021
Jetson TX2 - Failed to flash device Jetson TX2	35	3617	October 18, 2021
Flash tegra tx2 device failed Jetson TX2	4	655	May 17, 2018
Cannot flash tx2i Jetson TX2 boot	20	854	October 18, 2021
Jetson TX2 usb port not working after flashing Jetson TX2 reflash	8	91	August 9, 2024
TX2 Fails to Boot ROM communications Jetson TX2	18	9273	December 26, 2019
Configure USB flashing port Jetson TX2 usb	3	639	July 26, 2023
TX2 - Jetpack 3.2 flash failed Jetson TX2	5	1249	October 18, 2021
Jetson tx2 os flash error Jetson TX2	4	637	March 9, 2020