Force Recovery Mode of Jetson Xavier Series


I discover that there are two versions of procedures about Putting Developer Kit into Force Recovery Mode.
One is from Jetson AGX Xavier Developer Kit User Guide. This is what I am always using :

  1. Connect the developer kit as described above. It must be powered off.
  2. Press and hold down the Force Recovery button.
  3. Press and hold down the Power button.
  4. Release both buttons

Another is from Documentations Nvidia.

1.Power on the carrier board and hold the RECOVERY button.
2.Press the RESET button.

Are they both correct ways of putting force recovery mode or there is a problem of version update?


Both are correct. If the device is in power-off, we can hold force-recovery button and press power button to enter recovery mode. If the device is power-on, we press reset button.

1 Like

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.