Getting an error while using the SDK manager to flash my Jetson Orin Nano

Robotics & Edge Computing Jetson & Embedded Systems Jetson Orin Nano
1

SDK Manager 2.1 on Ubantu 20.04 it detects the board and I begin to flash and it gets to about 30% then throws:

08:07:31 ERROR: Flash Jetson Linux - flash: — Error: Reading board information failed.
08:07:31 INFO: Flash Jetson Linux - flash: [ NV_L4T_FLASH_JETSON_LINUX_COMP Install took 29s ]
08:07:31 ERROR: Flash Jetson Linux - flash: command terminated with error
08:07:31 SUMMARY: DateTime Target Setup - target: Depends on failed component

Any ideas?

2

NEVERMIND… I had the recovery jumper in during the flash, I did need it in recovery to be detected but had to remove it before flashing.

3

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.