Last Friday, I updated the Driveworks on my PX2 from 0.2.1 to 0.3;
And the version of aurix is 2.02.04.
And the ip adresses were:
all the three can connect with each other, I used “ping” to test.
However, I can’t use ethernet to connect my-pc and px2,
the command “ping” always output like that:
destination host unreachable.
I am sure the cable is ok.
So, where is the problem?
I am going crazy on this problem.
Could you please let me know the following and provide logs, this will enable our engineering team to understand the setup more clearly .
- On Aurix Console
a.Check output of “version” command and “status” command , below should be the default IP address set in Aurix
i. IP-address (Tegra-A): 10.42.0.28
ii. IP-address (Tegra-B): 10.42.0.29
iii.IP-address (AURIX): 10.42.0.146
- On Target Console (Tegra A) check the following
b. nvidia@nvidia:/usr/local/driveworks-0.3/bin$ cat /etc/nvidia/version-nv-pdk.txt
c. nvidia@nvidia:/usr/local/driveworks-0.3/bin$ cat /etc/tacp/tacp.cfg
Here IP’s should match for Aurix and Tegra
3) In case IP’s are correct try pinging Aurix from Tegra Console and check for packet loss