We are designing a carrier board for NX. In the design doc, it shows we can configure 2 x4 lane cameras plus 2 x2 lane cameras. NX has CSI0-4. So my understanding is that we can configure CSI0,CSI1 into 14lane. CSI2,CSI3 can be 22 lanes. CSI4 is 1*4 lane. Is this correct? Thanks.

How to configure the 12 lane CSI into 24 lane and 22lane

ShaneCCC February 8, 2022, 9:13am 3

CSI0/CSI1 and CSI2/CSI3 can be 24 lanes or 42lanes
However CSI4 only can be 14lnaes or 12lanes or 1*1lanes

Topic		Replies	Views
NX 5 camera CSI-2 lanes, 1 CSI-4 lanes Jetson Xavier NX camera , board-design	4	1135	October 3, 2021
Xavier nx csi port Jetson Xavier NX camera	4	563	September 11, 2023
Jetson Xavier NX Developer Kit 4 lane CSI camera Jetson Xavier NX camera	16	4714	July 21, 2021
CSI Interface for 4 Lane Camera Jetson Xavier NX camera	2	770	October 18, 2021
Basic question about configuration for cameras Jetson Xavier NX camera , kernel	3	431	September 7, 2022
Xavier NX camera number of supported cameras Jetson Xavier NX camera , board-design	2	692	April 13, 2022
CSI Interface -- Can we increase the lanes Jetson TX2	1	539	March 1, 2018
Orin Nano/NX CSI 4lane configuration Jetson Orin Nano camera	9	95	April 9, 2025
Can you configure Orin NX MIPI CSI for one 4-lane plus two 2-lane cameras? Jetson Orin NX camera	2	687	November 7, 2022
Valid Camera Input configurations on Jetson AGX Xavier Jetson AGX Xavier	5	1295	October 18, 2021