I’d like to use TX1 CAMx_MCLKs on J22 of TX1 Dev kit for general applications but I could not find information on how to enable and configure CAMx_MCLKs. Thanks in advance for directions on how to enable and configure CAMx_MCLKs.

How to enable and configure CAM_MCLKs

ShaneCCC March 24, 2017, 8:49am 2

Hi
There’s a sysfs can control it. /sys/kernel/debug/clock/mclk

Topic		Replies	Views
Question About CAM0_MCLK output Jetson TX2	3	720	October 18, 2021
MCLK set on TX1 Jetson TX1	4	626	October 18, 2021
About CSI camera master clock Jetson TX1	9	3372	August 4, 2016
Manual control of camera input clocks on TX2 Jetson TX2	6	1386	November 27, 2018
CAM2_MCLK on TX2 r28.1 clock rate Jetson TX2	3	974	October 18, 2021
Enable CAM0_MCLK on A02 devkit board Jetson Nano camera , hw	3	991	October 15, 2021
CAM_MCLK required? Jetson TX1	9	1512	October 18, 2021
CAM1_MCLK Jetson TX1	6	1045	October 18, 2021
How to enable csi camera mclk? Jetson TK1	3	2737	August 3, 2016
How to change clock configurations in the kernel device driver module at jetson TX1 R28.2? Jetson TX1	4	774	October 18, 2021