How to set up a Jetson with a 2d gimbal

Hello everyone,
I developed a tracking algorithm with the jetson xavier nx. All very nice and efficient.

Step 2 of my thesis work would consist of moving the camera attached to the jetson (arducam) to make sure that the target is in the center of the video.
How can I do this?
I read something about the Gimbal 2d and some libraries related to Raspberry.
Does anyone have ideas on how to proceed?
Even knowing the right hardware to attach to the jetson.



Sorry that our experience with the 2D Gimbal camera is limited.
Maybe you can check with the vendor to see if they support the ARM/Jetson platform first.


This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.