Hello,
I am using orin nx custom carrier board, here i found that i2c7 (i2c@c250000) pull low after device being detected on i2c through i2cdetect command.
I have tried to change clock 100k and 400khz, but the issue is same.
can you help please me to debug this issue ? and how can I update drive strength of i2c ?
Thanks
Hi
There are some registers to control this, please see Why Jetson 35.2.1 reduced drive strength on CAM_I2C lines, which caused camera to fail? - #8 by jhnlmn for reference
Regards,
Allan Navarro
Embedded SW Engineer at RidgeRun
Contact us: support@ridgerun.com
Developers wiki: https://developer.ridgerun.com/
Website: www.ridgerun.com
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.