Internal pullup and pulldown

[ozguryildiz]

Hi @Airodtech-Toulouse ,

You can find the jetson-tx2-module-pinmux datasheet here.

Log in

The topic has been discussed before so it might be useful to check it.

Change a GPIO pin internal pull-down to pull-up

Hi I’d like to change a GPIO pin’s internal pull-down to internal pull-up. The GPIO pin is GPIO17_MDM2AP_READY. This pin is internal pull up on TX1, but it is changed to internal pull down as a default on TX2. So, I refered to the chapter “TX2 Configuring Pinmux GPIO and PAD” in the document “NVIDIA Tegra Linux Driver Package Development Guide 28.1 Release”. According to this document, I created dtsi files, converted to cfg files, and placed them to /bootloader/t186ref/BCT on the host PC. Pla…

Another subjects which are similar can be found below.

How to configure a GPIO on TX2?

Use “sudo” (you need to be root). E.g.: sudo echo 123 > /sys/class/gpio/export Or stay sudo by using a root shell: sudo -s cd /sys/class/gpio/ echo 123 > export echo out > direction && echo 1 > value exit

how to configure gpio as pull up

hi, i want to use gpio388 as gpio input,is working right in Jetpack 3.2,when i port to Jetpack 4.2 the gpio is always read as lo,i think maybe need to config pull up,my device tree is like this gpio@2200000 { vol-up { gpio-hog; input; gpios = <TEGRA_MAIN_GPIO(I, 4) 0>; label = "vol-up"; status = "okay"; }; };

Regards.