Issues with PWN when running python file

[mhd0425]

I have a feeling you haven’t tried the jetson-io tool. Configuring the pins in python isn’t enough. CHeck the documentation again.

11. PWM

See samples/simple_pwm.py for details on how to use PWM channels.

The Jetson.GPIO library supports PWM only on pins with attached hardware PWM controllers. Unlike the RPi.GPIO library, the Jetson.GPIO library does not implement Software emulated PWM. Jetson Nano supports 2 PWM channels, and Jetson AGX Xavier supports 3 PWM channels. Jetson TX1 and TX2 do not support any PWM channels.

The Jetson.GPIO library does not dynamically modify the pinmux configuration to achieve this. Read the L4T documentation for details on how to configure the pinmux.

Running two simple DC motors (5 Amp) Forward and Backward in Jetson Nano

please check pinmux for pin available settings, there’re Pin-206/GPIO07, Pin-228/GPIO13, and Pin-230/GPIO14 available for PWM configurations. please refer to the pinmux spreadsheets for the default pin configurations, please also check Configuring the 40-Pin Expansion Header with Jetson-IO tool to simplify the configuration of the I/Os exposed by the 40‑pin expansion header. thanks