JetPack

Teaching a course for high school students focusing on Autonomous Vehicles. When trying to flash the TX1, it never gets to the point asking for the IP Address and log in. Anybody have an idea what could cause this issue? Also, at times the TX1 board won’t go into Force Recovery Mode to finish the flashing. I feel like there are a lot of issues. Could use any help provided. Thank you.

Hi lars.londotdkzjq,

Are you connecting the Jetson and PC over wireless network?
Please connect them over Ethernet cable, either directly or through a router or switch.

Thanks

Thank you. I will try that.