Hi, I am debugging a image sensor module called imx586, the resolution is 8000X6000, the sensor’s register has been configured successfully, 4 lanes of sensor hardware MIPI signaling are all outputting normally, but when I ran the command: v4l2-ctl --set-fmt-video=width=8000,height=6000,pixelformat…

hello wjv321, discarding frame failure means VI engine did not receive signaling correctly. please access Sensor Software Driver Programming Guide to review DT properties settings. you should increase max_pixel_rate property settings since it’s extreme large resolution. please also refer to Maxim…

Jetson AGX Xavier can not capture raw data, discarding frame

Robotics & Edge Computing Jetson & Embedded Systems Jetson AGX Xavier

shqli_linux December 4, 2019, 9:22am 3

hello JerryChang,

is it that the max value of the active_w parameter in dts is 6144?

How to configure DTS and bring up imx582 for AGX Xavier

Topic		Replies	Views
Need help on mipi FPGA and Xavier NX without i2c Jetson Xavier NX camera	3	911	March 28, 2022
Custom Xavier NX board: `no reply from camera processor` Jetson Xavier NX camera , device-tree	14	1561	November 16, 2022
GMSL camera port problem on Jetson AGX Xavier Jetson AGX Xavier camera	4	638	June 2, 2023
Xavier - using raw CSI without i2c Jetson AGX Xavier	9	3833	October 18, 2021
Xavier camera issue with max96712+max9295+ar0233 Jetson AGX Xavier camera	9	3313	October 18, 2021
No cameras available in Xavier NX Jetson Xavier NX camera	11	1754	October 18, 2021
V4L2 Camera Driver Development for Custom Camera - Device Tree - CSI - Uncomplete data Jetson Xavier NX camera , device-tree	3	1907	October 18, 2021
How does jetson tx2 support virtual channels? Jetson TX2 camera , kernel	14	1571	December 22, 2021
Need help on MIPI between FPGA and Xavier NX Jetson Xavier NX camera	4	675	April 20, 2022
No CSI traffic is received from CSI custom sensor Jetson AGX Xavier camera	13	889	December 22, 2021

Jetson AGX Xavier can not capture raw data, discarding frame

Related topics