Jetson Audio SFC Setup

Hi, I am now configuring Jetson audio system to achieve the following audio output path,

ADAMIF3 → SFC1 Mux → ADAMIF2 → I2S4 Mux → codex

when I want to switch on “SFC1 init” control, it always fails. I used the following setup.

amixer -c tegrasndt210ref cset name=“SFC1 init” “on”
amixer -c tegrasndt210ref cset name=“SFC1 Mux” ADMAIF3
amixer -c tegrasndt210ref cset name=“ADMAIF2 Mux” SFC1
amixer -c tegrasndt210ref cset name=“I2S4 Mux” ADMAIF2

Kindly refer to troubleshooting section to see if can help.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.