I tried to setup Jetson Nano 2GB for the first time today as follows and it doesn’t boot. How do I debug this? I am afraid the board might be dead.
Headless setup:
- Quick formatted a new 64 GB Samsung High Endurance micro SD card
- Flashed the Jetson Nano 2GB image on the micro SD card using Etcher.
- Insert microSD into Jetson Nano
- Plugged in micro USB-C 3 Amp power supply and connected Micro USB type A to USB port of a Windows 10 machine with Putty.
Expected: Jetson Nano should enumerate as a virtual Com port in Windows device manager.
Observed: Green LED turns on but nothing else happens. No new device is detected in Device manager.
With display setup:
- Quick formatted a new 64 GB Samsung High Endurance micro SD card
- Flashed the Jetson Nano 2GB image on the micro SD card using Etcher.
- Insert microSD into Jetson Nano
- Plugged in micro USB-C 3 Amp power supply and connected display via powered HDMI to VGA adapter, Keyboard and mouse.
Expected: Jetson Nano setup should show up on display
Observed: Green LED turns on but nothing else happens.