Jetson Nano Boot Loop

Hey all

I’ve been experimenting with some Nano’s. I’ve done development on a 2gb board for a while, and just got a 4gb board. I plugged the SD card I’ve been using in the 2gb board into the 4gb board (yes, I should have read the manuals on compatibility first). It didn’t load. So I plugged it back into the 2gb board. Now it’s stuck in an infinite loop where I see the Nvidia boot splash screen, then it resets, shows the screen, resets, etc.

I have backups thankfully, but am wondering if there’s any way to resurrect the 2gb SD card so I don’t have to reinstall everything. Thoughts?

hello dbrownrxvs0,

we’ll need logs for understand the root-cause,
please refer to Jetson Nano - UART - JetsonHacks to setup serial console and gather the logs.

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.