after apt-mark hold, change value of 0x10 registor of I2C bus 1. the jetson system can not work. flash failed . what can ido
Please click the export logs from sdkmanager GUI to share the whole log.
It may not help much to share just a screenshot. Also, is your host machine a VM? Sdkmanager does not support on VM.
this is the log, thank you
SDKM_logs_JetPack_4.5.1_(rev._1)_Linux_for_Jetson_Nano_2023-01-30_13-27-57.zip (125.2 KB)
SDKM_logs_JetPack_4.6_(rev._3)_Linux_for_Jetson_Nano_modules_2023-02-02_17-50-54.zip (55.1 KB)
This is Jetpack 4.6 log , thank you
You messed up your module eeprom so flash script does not let you flash.
Is your board still able to boot up?
Same issue as this one
SDKM_logs_JetPack_4.6_(rev._3)_Linux_for_Jetson_Nano_modules_2023-02-02_19-03-15.zip (83.4 KB)
my board is A02, the sdkmanager shows jetson nano. however, the process still failed. please check the log
No, I know you cannot flash the board. I already explained the reason in previous comment…
I may not express myself clearly. I know what you mean. I just used b01 image to burn A02 board only once, the log is SDKM_logs_JetPack_4.6_(rev._3)_Linux_for_Jetson_Nano_modules_2023-02-02_17-50-54.zip. THIS was a just try after I used sd card method, source code compilation method and image method. After I changed I2C Value of register address（BUS 1 11 ADDRESS） using I2C detect tool, my board can not boot up. Source code compilation method failed, but code compilation method can flash before change I2C value. Attached are pictures and log. I have check the Jetson Nano A01
So please refer to the above posts I shared…
所以麻煩參考我上面貼的那篇post…
I think the change of register value caused the board model mismatch. How can i reset all value of registers or use SD card boot?
I already told you the cause of this issue in above comment… your issue comes from you ruined the eeprom value when doing any kind of i2c work…
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.