JETSON NANO with OV9281 Camera Hardware

Hi, I have 2 Arducam OV9281Cameras and Jetson Nano. Its good that Nano has 2 camera port but to make interface with OV9281, do I need any extra board or it shall work directly?

Also, later I am planning to put three same cameras with Nano, in that case what sort of Multiplexer do I need? I have used Arducam Multiplexer with Rpi 4B module, but how about with Nano, its same or different?

Thank you

Nano only support two sensors, need design customized carrier board for it.