I am designing a carrier for the Orin nano, i have a question about the M2. Alert signal for the M2. M.
Can i use GPIO10 (pin 212) on the Orin for this purpose?
Thanks
scott
I am designing a carrier for the Orin nano, i have a question about the M2. Alert signal for the M2. M.
Can i use GPIO10 (pin 212) on the Orin for this purpose?
Thanks
scott
Sure, pin 212 is used as this on devkit carrier.
It’s a GPIO with wake function.
ok, so in pinmux just set as GPIO_PEE.02 ?
Yes, keep it as default setting: GPIO3_PEE.02
perfect, thanks a lot.
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.