greetings,
i’m having issues with my jetson nano super - it wont work with the microsd card image - tried both the old 5.x and newer 6.x image.
I’ve tried two different microsds - no change in where it stops on boot up - same the output
I’ve dumped the output from serial console
output.txt (80.9 KB)
please advise on how to proceed. I also tried to use SDK manager but it wont detect the nano using usb-c to usb-c.
Assuming you have a the jumper wire installed.
Also, wipe your media, blank no partition.
Select download only then after its downloaded then install.
Try a different SD card if a wipe does not fix it.
If you have a stale download and build, delete that and start over with fresh after the sdkmanger upgrades to the current version.
Hi,
Please connect the developer kit to type-A port on host PC through type-C to type-A cable. So that the developer kit can run in USB device mode.
This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.