Module NVDEC stops working

Please provide complete information as applicable to your setup.

**• Hardware Platform Jetson nano 4G
**• DeepStream Version6.x
**• JetPack Version (valid for Jetson only)4.6
• TensorRT Version 8.x
**• Issue Typequestions
I successfully ran example deepstream-imagedata-multistream.I have access to 4-way webcam at the same time.The program runs normally and module NVDEC works normally. The specific operation is shown in Figure 1. After running for a period of time, module NVDEC frequently switches between on and off.The specific operation is shown in Figure 2

Figure 1

Figure 2

What’s going on?

Have you enable the max power mode of our board?

Yes, I’ve opened it.The corresponding information can be viewed in the picture

The NVDEC is the hardware encoder. The power switch is just to save power when there is no encoding task.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.