Need manually applied firmware update when insert JP4.5 updated SD-card?

Autonomous Machines Jetson & Embedded Systems Jetson Nano
#1

I have a couple of jetson development boards and use one sd-card image for all.

I updated the master-image to jetpack 4.5 and noticed, he did some post-install updates (flash/bootloader…).

The question is: when I put the sdcard with JP4.5 in an jetson device, which was not updated before (in extreme a old rev A.02 board) - is it working out of the box or do I have to prepare the hardware by manually executing any scripts? Or does he do this on first boot?

Thank you!

#3

The sdcard image shall flash the qspi in your first boot up configuration.

If you are worried about something might missing, you could also just flash the board with sdkmanager.

1 Like
#5