Nvidia jetson NX working on mode 0 reboot always, why? who can tell me what's wrong?

nvidia@nvidia:~$ [ 106.888427] hub 2-3:1.0: hub_ext_port_status failed (err = -110)
[ 116.968420] hub 2-3:1.0: hub_ext_port_status failed (err = -110)
[ 127.048395] hub 2-3:1.0: hub_ext_port_status failed (err = -110)
[ 137.128244] hub 2-3:1.0: hub_ext_port_status failed (err = -110)
[ 147.207779] hub 2-3:1.0: hub_ext_port_status failed (err = -110)
[ 157.287470] hub 2-3:1.0: hub_ext_port_status failed (err = -110)
?
[0000.024] W> RATCHET: MB1 binary ratchet value 4 is too large than ratchet level 2 from HW fuses.
[0000.033] I> MB1 (prd-version: 1.5.1.3-t194-41334769-d2a21c57)
[0000.038] I> Boot-mode: Coldboot
[0000.041] I> Chip revision : A02
[0000.044] I> Bootrom patch version : 15 (correctly patched)
[0000.049] I> ATE fuse revision : 0x200
[0000.053] I> Ram repair fuse : 0x0
[0000.056] I> Ram Code : 0x0
[0000.058] I> rst_source : 0x0
[0000.061] I> rst_level : 0x0
[0000.065] I> Boot-device: QSPI
[0000.067] I> Qspi flash params source = brbct
[0000.071] I> Qspi using bpmp-dma
[0000.074] I> Qspi clock source : pllp
[0000.078] I> QSPI Flash Size = 32 MB
[0000.081] I> Qspi initialized successfully
[0000.085] W> No valid slot number is found in scratch register
[0000.091] W> Return default slot: _a
[0000.094] I> Active Boot chain : 0
[0000.097] I> Boot-device: QSPI
[0000.100] I> Qspi flash params source = brbct
[0000.106] W> MB1_PLATFORM_CONFIG: device prod data is empty in MB1 BCT.
[0000.113] I> Temperature = 29500
[0000.116] W> Skipping boost for clk: BPMP_CPU_NIC
[0000.121] W> Skipping boost for clk: BPMP_APB

Hi,

Sorry, but I cannot tell anything helpful in your log. What was your purpose posting this log?

Please describe more detail for your issue. How often does your board reboot? Could you tell any special case that would trigger the reboot?

Duplicated with Nvidia jetson NX working on mode 0 reboot always, why? who can tell me what's wrong?