(NVIDIA Jetson TX2 ) SDK Manager can't detect Target Hardware "no board connected"

[kayccc]

I can’t answer this due to officially flashing Jetson devices from VM is not supported, but you may refer to below topic to see if can help:

Successfully flashed Jetson Nano emmc module through virtualbox on OSX

Just wanted to share the settings I found that enabled me to run flash.sh successfully through a virtualbox Ubuntu18.04 VM set up through vagrant on OSX: Rough steps: use brew to install vagrant, virtualbox add vagrant box generic/ubuntu1804 for virtualbox resize vagrant ubuntu1804 image to 60GB $ cd ~/.vagrant.d/boxes/generic-VAGRANTSLASH-ubuntu1804/2.0.6/virtualbox/ $ VBoxManage clonehd generic-ubuntu1804-virtualbox-disk001.vmdk generic-ubuntu1804-virtualbox-disk001-resized.vdi --format V…