NVIDIA Jetson wont boot

Robotics & Edge Computing Jetson & Embedded Systems Jetson Nano
,
1

Hello All,

I recently purchased an NVIDIA Jetson 2GB developer kit. I have tried multiple times to get it to boot up after following the instructions on NVIDIA’s page for the board.I am on a Windows computer. I used etcher to burn the jetson image “sd-blob-b01” to a Sandisk Extreme Plus 32 GB. But it seems that no matter how many times I try to redo it, it does not want to move past the NVIDIA screen. I have the B01 version model P3541. I am confident it is getting enough voltage. I purchased the CanaKit USB-C power supply to power it. The green light stays on the whole time, I do notice it reboots every few minutes or so. If anyone could give me any suggestions it would be greatly appreciated.

3

There is no update from you for a period, assuming this is not an issue any more.
Hence we are closing this topic. If need further support, please open a new one.
Thanks

  1. I understand you may only have a windows computer. But still suggest you to find a ubuntu host and try sdkmanager

  2. Are you sure you are using jetson nano 2gb image but not 4gb image?

  3. Are you able to dump the boot up log from uart?
    Jetson/General debug - eLinux.org