NVIDIA logo blinking on first boot

I used my macbook and followed the Write Image to the microSD Card steps here:Getting Started With Jetson Xavier NX Developer Kit | NVIDIA Developer
I did the Etcher Instructions and the image appeared to write successfully. I then ejected it, plugged it into my Xavier, plugged in HDMI to my monitor, plugged in power cable, and hit power button.

When it powers up, it gets to NVIDIA logo screen, goes black, and then repeats between logo and black screen indefinitely.

What might be causing this and how can I fix?

  1. To check the log, you can follow below method.
  1. To fix this, you need to find a ubuntu 18.04 x86_64 host and flash your board with sdkmanager.

  2. This is jetson agx forum. Not NX fourm.

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.