Orin NX: Frame loss when encoding 6 UHP H265 1080p60 streams

Dear Nvidia Support,

I am trying to confirm the performance listed in the Orin NX data sheet(linked below), however I get dropped frames when testing UHP H265 1080p60 with 6 streams using Gstreamer with a video source that has a bitrate of 23,268 kb/s.

I am using a custom carrier board and running L4T 36.4.4.

Jetson-Orin-NX-Series-Modules-Datasheet_DS-10712-001_v1.6.pdf

I was wondering if you could provide some insight into how you confirmed those results?

  1. What bitrate you used?
  2. Did you use Gstreamer?
  3. Did you use a video from a camera?

Thank You

Hi,
Please run the steps to fix NVENC engine at maximum clock:

Making sure you're not a bot!
[gstreamer/MMAPI] cannot run hardware encoder in maximum performance mode

This shall bring maximum throughput in hardware encoding. Please give it a try.

Thanks for sharing that information.

I will try this and see if I still drop frames.

While I try using max performance.

I would still like to know how you confirmed the specifications in the data sheet.
I am trying to remove discrepancies between my tests and Nvidia’s test.

Could you possible provide some information about how you conducted your tests?

Thank You

Hi,
Please run the commands and check fps of each encoding process:

$ sudo jetson_clocks
$ gst-launch-1.0 videotestsrc num-buffers=1200 is-live=1 ! video/x-raw,width=1280,height=720,framerate=60/1,format=NV12 ! nvvidconv ! "video/x-raw(memory:NVMM),width=1920,height=1080" ! nvv4l2h265enc ! fpsdisplaysink text-overlay=0 video-sink=fakesink sync=0 -v & \
    gst-launch-1.0 videotestsrc num-buffers=1200 is-live=1 ! video/x-raw,width=1280,height=720,framerate=60/1,format=NV12 ! nvvidconv ! "video/x-raw(memory:NVMM),width=1920,height=1080" ! nvv4l2h265enc ! fpsdisplaysink text-overlay=0 video-sink=fakesink sync=0 -v & \
    gst-launch-1.0 videotestsrc num-buffers=1200 is-live=1 ! video/x-raw,width=1280,height=720,framerate=60/1,format=NV12 ! nvvidconv ! "video/x-raw(memory:NVMM),width=1920,height=1080" ! nvv4l2h265enc ! fpsdisplaysink text-overlay=0 video-sink=fakesink sync=0 -v & \
    gst-launch-1.0 videotestsrc num-buffers=1200 is-live=1 ! video/x-raw,width=1280,height=720,framerate=60/1,format=NV12 ! nvvidconv ! "video/x-raw(memory:NVMM),width=1920,height=1080" ! nvv4l2h265enc ! fpsdisplaysink text-overlay=0 video-sink=fakesink sync=0 -v & \
    gst-launch-1.0 videotestsrc num-buffers=1200 is-live=1 ! video/x-raw,width=1280,height=720,framerate=60/1,format=NV12 ! nvvidconv ! "video/x-raw(memory:NVMM),width=1920,height=1080" ! nvv4l2h265enc ! fpsdisplaysink text-overlay=0 video-sink=fakesink sync=0 -v & \
    gst-launch-1.0 videotestsrc num-buffers=1200 is-live=1 ! video/x-raw,width=1280,height=720,framerate=60/1,format=NV12 ! nvvidconv ! "video/x-raw(memory:NVMM),width=1920,height=1080" ! nvv4l2h265enc ! fpsdisplaysink text-overlay=0 video-sink=fakesink sync=0 -v &

Thank you for the gstreamer command/pipeline.

I will adapt my test to this pipeline.