Power specification for no dGPU and no CIM

Autonomous Vehicles DRIVE AGX Xavier DRIVE AGX Xavier General
1

Hi,
I have question about documentation of “NVIDIA DRIVE AGX DEVELOPER SYSTEM MECHANICAL INSTALLATION GUIDE”.

Table.5 shows ‘System EDP’ is 38A@12V in case of 2 SoCs without dGPU.
But it case seems including CIM.

Do you have power specification for the board only?
If we don’t use CIM and other sensors/devices, how much power system do we need?

2

Dear yk-fujii,

Please refer to the Note 1, 2 in Table.5

Note :

  1. CIM is included in all above configurations, but CVM and COMEX are not included.
  2. The current consumption of the debug interfaces on the rear side of the Developer System, as shown in Figure 6, are not included.

Do you have power specification for the board only?
If we don’t use CIM and other sensors/devices, how much power system do we need?
Could you please contact your NVIDIA representative for above information? Thanks.