Is this correct for r32.3.1
Can you review this and make corrections please.
I am confused by this section.
Enabling the New DTB
The r28, r32 release must update the dtb by below command.
sudo ./flash.sh -r -k kernel-dtb jetson-tx2 mmcblk0p1
Do not update the DTB by below for r28. r32 and later release. As in Jetson/TX2 DTB, enable FDT in /boot/extlinux.conf
I used dd to copy my compiled dtb to /dev/mmcblk0p30 but it bricked my system.
For the dd part, see:
https://devtalk.nvidia.com/default/topic/1071397/jetson-tx2/r32-3-1-dding-output-from-dtc-into-dev-mmclbk0p30-will-brick-jetson-tx2-endless-cboot-loop/post/5428031/#5428031
The unit will work again once flashed with the signed device tree.
The point is that the web page in the subject is in need of updating, and I do not know who to tell
Terry
If you are asking about the eLinux.org page, I believe he has been notified. In terms of web pages of devtalk.nvidia.com, several people will see this every day, and is actively updated.