Reflash Jetpack 6.2 but met waiting for target to boot up

Robotics & Edge Computing Jetson & Embedded Systems Jetson Orin Nano
1

I’m using ubuntu 20.04 and I’m trying to reflash my jetson orin nano with jetpack 6.2 to enable more power mode, but I was stuck in waiting for target to boot up until it says time out. I used

sudo ./tools/kernel_flash/l4t_initrd_flash.sh --external-device nvme0n1p1 -c tools/kernel_flash/flash_l4t_t234_nvme.xml -p "-c bootloader/generic/cfg/flash_t234_qspi.xml" --showlogs jetson-orin-nano-devkit-super internal

to reflash jetson. And how do I retrieve logs in this case?

2

log.txt (336.6 KB)
I copied the terminal log and uploaded here in case you need it.

3

Using ubuntu 22.04, I encountered the same “Waiting for target to boot-up” problem, on 2 brand new orin nano devkits with SSD drives (Crucial PCIe 3.0 NVMe 0.5TB). Very frustrating.

On the other hand, if I only flash the QSPI, that completes successfully, so communication between the devkit and ubuntu is good. But that’s only useful for the SD card method. Let’s see what Nvidia says.

5

Hi,

Please record the serial console log and attach it.
To record the serial console log, please refer below links

Thanks

7

Unfortunately I do not have any wire that would do the trick, is there any alternative ways to do so?

8

This topic was automatically closed 14 days after the last reply. New replies are no longer allowed.