Reset a USB ZED Camera through command line or other way?

I have Jetson AGX Xavier Developer Kit
I am trying to connect a USB ZED camera to it (type c port)

the camera is working fine but when restarting Jetson or powering off and on again
, ZED Camera doesn’t work until I remove manually USB cable

Is there a way to reset the connection of the USB cable by command (instead of manually disconnect the cable )

You may try to disable and enable the regulator. Here are commands for Type-A port:
Switch on and off usb ports programmatically on AGX - #5 by DaneLLL

1 Like

This topic was automatically closed 2 days after the last reply. New replies are no longer allowed.