Rotary Encoder - GPIO interrupts failing to fire

[WayneWWW]

Hi,

Sorry for late reply. Is your issue same as the one below?

GPIO input... stuck / not resetting?

Hi! I use following setup: [image] GPIO in is BCM pin 17 / board pin 11 GND is GND VCC is 3,3v I made this super basic script that says if it’s 1 or 0 when ran: #Pin Definitions input_pin = 17 # BCM pin 17, BOARD pin 11 def main(): GPIO.setmode(GPIO.BCM) GPIO.setup(input_pin, GPIO.IN) # set pin as an input pin value = GPIO.input(input_pin) print(value) the script seems to work only once, for example: When the switch is open I get 0 When I then close the switch I get 1 If I t…

We already started our investigation internally for this issue but not sure if your topic is same as this one.