Run "stress --hdd 6" on eMMC or SD card boot cause the Xavier NX reboot issue

Robotics & Edge Computing Jetson & Embedded Systems Jetson Xavier NX
1

Hi ,
I use the Linux stress testing software “stress” on XAVIER NX for stress testing. Executing the parameter “stress --hdd 6” will cause the system reboot after a while. About stress for 5~6 hours.
This problem occurs regardless of whether it is eMMC or SD card boot.
Is this a limitation or a bug?

The procedure is as follows:

$ sudo apt-get install stress

$ stress --hdd 6

3

Any log from uart during the reboot?

4

Hi,
Please refer to Annex.

stress hdd_test.log (30.3 KB)

5

Hi,

Please disable the hung task timeout by setting below node to 0 and try your test again.

/proc/sys/kernel/hung_task_timeout_secs